Slat Wall with P-System

How it works:

Determine and mark spacing for Tenso connectors

Determine and mark spacing for each slat based on material thickness and reveal

 Extend marks for reference on top and bottom

Using a piece of scrap wood, cut spacers to match your reveal

Connect spacers to a straight edge with hot glue near the ends of the backer material

Align spacers with reference marks and clamp in place

Use the center marks for the Tenso connectors and make plunge cuts

Unclamp and repeat at each slat location on backer sheet

Mark the center line of slot locations on the slats

Make plunge cuts on the slats

Install Tenso connectors on slats and backer board

Snap slats into place on finished project